ColorFabb Laser Marking PLA – 3D Printing Filament

264.50 SAR

The laser marking PLA filament from Colorfabb offers laser markings and laser engravings. Its unique composition responds to fiber-based lasers and Nd: YAG (Neodymium-doped Yttrium Aluminum Garnet) solid-state lasers. Its key features include:

Unlimited design options in markings and engravings.
Permanent laser markings.
Laser engravings.
Waterproof.
Heat-resistant material.
Strong resistance against chemicals.
Prompt usage with no pre or post-treatment or procedure.
Compatible with laser engravers with 980 to 1064 nm wavelength.

Note: Not compatible with CO2-based laser markers or engravers.

Weight
Diameter	Clear

Quantity Qty

Description
Additional information

“Laser Marking PLA belongs to single use category. This unique material is optimized to be used with laser engravers within a 980-1064 nm wavelength. The material has been tested successfully with a Nd:YAG- and fiber lasers. Laser marking PLA will not work with CO2 lasers.

Laser marking has various advantageous over conventional marking technologies:
– Markings are permanent, waterproof, wear and heat resistant, lightfast and resistant to chemicals.
– Flexibility in marking design.
– No pre or post-treatment required.”

Material:colorFabb Laser marking PLA
Diameter Tolerance:± 0.05 mm
Density: 1.20 g/cm3
Glass Transition Temperature: 55C
Advised 3D printing temperature: 195-220C
Advised 3D print speed: 40 – 100 mm/s
Advised Heated bed: 50-60C

Additional Instructions
Laser Marking PLA contains a laser-sensitive additive optimized to work within a 980-1064 nm wavelength. The material has been tested successfully with a Nd:YAG- and fiberlasers. Laser marking PLA will not work with CO2 lasers.